Filter
Top Products
2-52 Chapter 2
Library Installation
Moving or Shipping the Library
Shipping a Library
CAUTION To prevent damage to library model 12/140, do not lay it on its side.
1. If the library is secured to the floor, remove the mounting brackets.
2. Raise the library’s leveler feet using a 1/2-inch open-end wrench.
3. If the ramp was removed from the shipping pallet, reattach it.
4. With at least two people, slowly roll the library up the ramp and onto
the shipping pallet (see Figure 2-18 on page 2-25).
5. Use a socket wrench to attach the front and rear pallet shipping
brackets to secure the library to the shipping pallet (see Figure 2-17
on page 2-24). Each bracket has four bolts.
a. Attach the two 7/16 bolts that secure each bracket to the library.
b. Attach the two 9/16 bolts that secure each bracket to the pallet.
6. Add the packaging materials to the library (see Figure 2-16 on
page 2-23):
a. Place the foam cushion onto the back of the library.
b. Place the plastic bag over the library to cover it.
c. Wrap the cardboard tube around the library.
d. Attach the four clips that secure the cardboard tube.
e. Place the cardboard cap on top of the library.
7. Attach four vertical banding straps to secure the ramp to the library,
and the library to the shipping pallet (see Figure 2-15 on page 2-22).