Filter
Top Products
Chapter 2 2-43
Library Installation
Connecting and Powering on the Library (for Model 12/140)
Library Installation
Library Installation
NOTE The AC power cord is the library’s main AC disconnect device and must
be easily accessible at all times.
7. Connect the power cord(s) from the library to a grounded power
receptacle, and power on the library. The standby switch is recessed.
8. After the power-on test completes, go to the front panel to configure
the library for Fibre Channel. See page 4-16 or page 4-18 for more
information.
9. Connect the remote management card (see “Configuring the Remote
Management Card” on page 4-10).
10.Power on the host.