Filter
Top Products
4-6 Chapter 4
Library Administration
Enabling and Changing the Password
Enabling and Changing the Password
NOTE All service and administration procedures are password protected. These
procedures include: diagnostic tests, configurations, online drive repair,
and setting the date and time. A password is also required to perform
these tasks through the remote management card.
CAUTION The password is cleared when you install or download new code to the
library controller card.
When the library is installed, the password is inactive. To protect the
system from unauthorized access, use the following procedure to set a
password.
1. Enter the
Password menu. A status screen will indicate if the
password is enabled.
• If the password is turned off, select
[Set New Password].
• If the password is turned on, select
[Change Password], and enter
the new password. It must be eight digits long.
• If the password is turned on, select [Turn Password Off] to clear the
password.
NOTE If you enter more than eight digits, the ninth digit will become the first
digit of the new password.
2. Select
[OK] to exit.
Main Menu ->
Service ->
Change Configuration ->
Password