Filter
Top Products
6-24 Chapter 6
Removing and Replacing Parts
Removing and Replacing Drive Modules
4. Grasp the ribbon cable that is plugged into the drive module. Remove
the cable by pulling the connector to the left (see Figure 6-8).
Figure 6-8 Ribbon Cable and Connector
5. Lay the connector assembly to the side, allowing the external cables
to hang from the connection(s). Do not disconnect external cables
from the connector plate.
6. Loosen the top and bottom thumbscrews on the drive module (see
Figure 6-9).
7. Using the handle that is mounted on the back of the drive module,
pull the drive module straight out with one hand while supporting
the bottom of the drive module with the other hand.
CAUTION As the drive module is pulled out, support the bottom of the drive module
to avoid dropping or damaging it.