Filter
Top Products
Chapter 6 6-43
Removing and Replacing Parts
Removing and Replacing the Transport Assembly (for Model 12/140
only)
Errors and Troubleshooting
Removing/Replacing Parts
Replacing the Transport Assembly
Install the replacement transport assembly by following these steps:
1. Connect the umbilical cable to the bottom of the library chassis.
CAUTION Use care to protect the flat, umbilical cable attached to the bottom of the
transport assembly. Do not bend the pins.
a. Align the gears on the transport assembly with the gear rails on
the library (Figure 6-22).
b. Check the gear teeth position to ensure they are aligned with the
gear rails and that the gear rails are level with each other
(Figure 6-22).
CAUTION The alignment of the gears with the gear rails is critical. The library will
test to ensure alignment.
Figure 6-22 Transport Assembly Position
A Gears incorrectly aligned 1 Gears
B Gear correctly aligned 2 Gear rails (racks)
3 Check points to ensure
alignment