Filter
Top Products
2-16 Chapter 2
Library Installation
Installing the Library into a Rack (for Model 2/20, 4/40, and 6/60)
• Model 4/40 and Model 6/60:
Use a mechanical lift that is rated to the weight of the library, and
follow the steps below to install the library.
a. Break away the edges of the packing material at the bottom of
the library.
b. Use the straps to ease the library onto an appropriately rated
mechanical lift. Use the lift to raise the library so that it aligns
with the bottom rails.
c. Slide the library onto the lower rails. Have at least one person
guide the library from the front and one person pull the library
from the back, using the vertical handle (Figure 2-8).
d. Remove the lifting straps once the library is partially installed.
Save the straps for future use.
Figure 2-8 Library Installation
CAUTION Do not push the library from the front. Use the handle shown in
Figure 2-8. DO NOT pull on the handle(s) located on the back of the
power supply or drive modules.