Filter
Top Products
4-26 Chapter 4
Library Administration
Setting SCSI IDs
NOTE The SCSI ID for a drive position can be configured, even when no drive is
present. When a drive is later added, it will use the ID already assigned
to that drive position.
CAUTION Changing SCSI ID settings may affect the backup software
configuration. Consult the backup software manual for SCSI ID
requirements.
1. Enter the SCSI IDs menu. A message warns users that devices with
the same SCSI IDs must be connected to different SCSI buses.
Select [OK].
2. The
Configure SCSI ID screen displays a message that indicates the
drive position selected.
Use the [-] or [+] key to select the drive or library controller, then
select
[OK]. Refer to “Library Back Panel” on page 1-7 or the pull-out
information tabs on the back of the library for the drive numbers.
3. The next screen displays the drive number and the current SCSI ID.
Use the
[-] or [+] key to select the desired SCSI ID, then select [OK].
4. A confirmation screen will indicate either a successful or failed
operation. If the SCSI ID assignment failed, the screen will indicate
the cause and then return to the
Configure SCSI ID screen.