Filter
Top Products
Chapter 2 2-7
Library Installation
Installing a Stand-alone Library into a Rack
Library Installation
Library Installation
Installing a Stand-alone Library into a Rack
To install a stand-alone library in a rack, remove the cover and feet by
following these steps:
1. Remove the following six screws (Figure 2-1):
a. Four 10-24 screws, one located at each of the four feet.
b. Two 10-24 screws near the bottom and at the back of the library.
2. Lift the cover off the library.
NOTE The cover may fit tightly. If you cannot remove it easily, ease the sides
out while lifting up on the cover.
Figure 2-1 Removing the Cover