Filter
Top Products
Chapter 2 2-33
Library Installation
Connecting and Powering on the Library (for Models 2/20, 4/40, and
6/60)
Library Installation
Library Installation
Figure 2-23 Fibre Channel Connections (Standard Performance Controller)
NOTE Your Fibre Channel interface type (standard or high performance) is
dependent on the drive technology in your library. To identify whether
you have the high performance or standard performance Fibre Channel
interface, see page 5-11.
CAUTION The Fibre Channel printed circuit boards may contain a laser system
(GBIC or GLM module) that is classified as a “Class-I Laser Product”
under a U.S. Department of Health and Human Services (DHHS)
Radiation Performance standard according to the Radiation Control for
Health and Safety Act of 1968 and EN60825-1(+A11) safety of laser
products. The compliance statement is located on the module.
6. Power on the hub or switch (if present).
7. Connect the power cord(s) from the library to a grounded power
receptacle, and power on the library. The standby switch is recessed
on the front of the library.
8. After the power-on test completes, go to the front panel to configure
the library for Fibre Channel. See page 4-16 or page 4-18 for more
information.