Filter
Top Products
2-46 Chapter 2
Library Installation
Verifying the Host Configuration
Verifying the Host Configuration
Installing the Backup Software and Drivers
Install and configure the host drivers, host backup software, and host
bus adapter (if you have not already done so).
Verifying the Configuration
To verify the installation, look for the library and drives after powering
up the host (see “Setting SCSI IDs” on page 4-25 for the library’s default
SCSI IDs).
• For Windows NT, go into
Settings Í Control Panel Í SCSI Adapter
• For HP-UX, run an “ioscan” as root
• For Sun Solaris:
1. Close all open applications and exit the Common Desktop
Environment (CDE).
2. Type “init 0” at any prompt. This will shut down all processes,
and take you to the OpenBoot PROM.
3. Type “reset”.
4. At the
OK prompt, type “probe-scsi-all”.
Run a test backup to ensure that all components are properly configured.