Filter
Top Products
Chapter 6 6-23
Removing and Replacing Parts
Removing and Replacing Drive Modules
Errors and Troubleshooting
Removing/Replacing Parts
4. Select [Put Drive Offline]. The front panel indicates the success or
failure of this operation.
Removing a Drive Module
NOTE To preserve SCSI communications, do not loosen or remove the SCSI
cable(s) connected to the outside of the drive module. The connection to be
removed is located inside the drive module. See Figure 6-8.
NOTE When the drive module has been successfully taken offline, one of the
LEDs on the back of the drive will be flashing yellow.
Remove the drive module using the steps below:
1. Verify the external SCSI cable is securely fastened to the connector
plate.
2. Loosen the thumbscrews on each side of the connector plate, located
in the middle of the drive module (Figure 6-8).
3. Gently remove the connector plate with SCSI cable(s) still connected.
CAUTION Use standard precautions for electro-static discharge (ESD) protection.