Filter
Top Products
Chapter 6 6-51
Removing and Replacing Parts
Removing and Replacing the Motherboard
Errors and Troubleshooting
Removing/Replacing Parts
7. Loosen the thumbscrew on the sheet-metal cover nearest the left
drive bay and rotate the cover clockwise (Figure 6-27).
Figure 6-27 Rotating the Sheet-Metal Cover
8. If the library is rackmounted, use the following steps to slide it
forward in the rack (for Models 2/20, 4/40, and 6/60 only):
CAUTION For Model 12/140, do not push the library out of the cabinet. Instead,
remove the side panels by using the procedure in “Accessing the Side
Panels for Service” on page 6-35.
a. Lower the leveler feet, and fully extend the anti-tip foot at the
front of the rack.
WARNING Failure to extend the anti-tip foot of the rack could result in
damage to the library and/or personal injury.