Filter
Top Products
Chapter 6 6-31
Removing and Replacing Parts
Removing and Replacing the Transport Assembly (for Models 2/20, 4/
40, and 6/60 only)
Errors and Troubleshooting
Removing/Replacing Parts
Removing the Transport Assembly
Use the following steps to remove the transport assembly:
1. Using the finger-holes in the top of the transport assembly, lift the
assembly up and out of the library (Figure 6-13).
CAUTION Use care to protect the flat, umbilical cable attached to the bottom of the
transport assembly when lifting.
NOTE The illustration on the left is for Models 4/40 and 6/60 and shows the
vertical lift assembly connected to the transport assembly. The
illustration on the right is for Model 2/20, which does not have a vertical
lift assembly.
Figure 6-13 Removing the Transport Assembly
2. Place the transport assembly on top of the library, and disconnect the
umbilical cable by pulling the tabs outward (Figure 6-13).