Filter
Top Products
4-18 Chapter 4
Library Administration
Configuring the Library for Fibre Channel (for firmware revisions
greater than 1.14)
Configuring the Library for Fibre Channel
(for firmware revisions greater than 1.14)
The optional Fibre Channel interface cards serve as a bridge between
SCSI and Fibre Channel. You can check the firmware version by going
into
Service -> Information-> Library Information.
NOTE It is not necessary to connect the library to its Fibre Channel topology
(arbitrated loop or fabric) before configuration.
Configuration
NOTE When Fibre Channel cards are installed in the library, device SCSI IDs
cannot be changed from their factory default.
Though you do not need to set SCSI IDs for Fibre Channel, you will need
to configure Fibre Channel addressing.
1. Enter the
Fibre Channel menu.
2. Select the level where the Fibre Channel interface card you want to
configure is located.
Use the
[-] key to select a lower level in the library.
Use the
[+] key to select a higher level in the library.
Select
[OK] if the level is correct.
Main Menu ->
Administration ->
Change Configuration ->
Fibre Channel