Filter
Top Products
Chapter 4 4-33
Library Administration
Running Service Diagnostic Tests
Library Administration
Library Administration
Running Service Diagnostic Tests
Use the following menu path to access service diagnostic tests:
Use the following procedure to run internal tests of library functions.
Table 4-8 describes these tests.
1. Enter the service password to access the
Service menu.
2. From the
Run Test menu, use the [-] or [+] key to view the available
tests.
3. Select [OK] to choose the test.
4. Select the number of test cycles.
5. Select
[Run] to start the test cycle.
The test results will display at the conclusion of the test.
Main Menu ->
Service ->
Run Test
Table 4-8 Diagnostic Tests
Test Description
Check Inventory Physically scans the entire library to identify bar codes and
determine which slots and drives contain tapes.
Recalibrate Library Performs the power-up self-tests. Each test runs one time per
test loop. This test recalibrates the mechanics, clears any
hard error, and then checks inventory.
Test Vertical Motion Moves the vertical assembly to the bottom of the library, then
to the top, while the transport moves around its lateral range.
Once these moves are completed, the transport assembly then
stops.
NOTE: This test is functional in all library models, but only
moves upward in multi-level libraries.