Filter
Top Products
6-26 Chapter 6
Removing and Replacing Parts
Removing and Replacing Drive Modules
Installing a Drive Module
1. Hold the drive module with one hand on the drive module handle
while the other hand supports the bottom (Figure 6-10).
2. Install the drive by inserting the rail at the top of the drive module
into the slot at the top of the drive module opening.
Figure 6-10 Installing a Drive Module
3. Tighten the top and bottom thumbscrews, securing the drive module
into the library.
4. Remove the new connector plate from the replacement drive.
5. Install the original ribbon connector and plate inside the replacement
drive module (Figure 6-8 on page 6-24).
6. Gently fold the ribbon cable (attached to the plate and SCSI cable)
into the back of the drive module.