Filter
Top Products
Chapter 3
70
Exabyte 440 and Exabyte 480
Checking the setup
After installing the hardware and software, check the setup by
performing some exercises on the library. (While these exercises
are not required, it is a good idea to verify that your software and
hardware are communicating properly before you begin
operations.)
Use the options on the Diagnostic Menu to exercise the
hardware. This determines whether the library hardware
components are operating properly. See Chapter 7 for
instructions.
Instruct the application software to load some cartridges into
each tape drive. This determines whether the software and
library are communicating properly.
Back up several megabytes of data to each tape drive and
perform a comparison check on the backed up data. This
determines whether the software and tape drives are
communicating properly.
If problems occur...
If the library and tape drives are
not operating as expected
See Chapter 8 for
troubleshooting information.
If there is an error code displayed
on the LCD
See Appendix C for a list of error
codes and corrective actions.
If you cannot solve the problem
yourself
Contact your service provider or
Ex ab yt e.