Filter
Top Products
Hardware Installation
Installation and Operation
23
7. If the holes in the rack are not threaded, install a clip nut on
each side of the rack in line with the screw hole in the front
panel of the library, as shown in the following figure.
8. Slide the library completely into the rack. Using a T-25 TORX
screwdriver, insert the two 10-32 × 1.0 pan head screws into
the front panel, as shown in the following figure. These screws
prevent the library from sliding out of the rack.
9. Replace the air filter grilles on each side of the front panel.