Filter
Top Products
LCD Error Codes
Installation and Operation
161
The following table lists the library hardware error conditions in
numerical order.
Error Description Corrective action
10
DROPPED A CARTRIDGE. The
CHM dropped a cartridge.
If the cartridge label was removed, make sure
that there is no label adhesive remaining on
the cartridge. If the label was not removed,
contact your service provider.
CAUTION: Do not try to put the cartridge back
in the gripper.
11
SOURCE EMPTY. There is no
cartridge in the source
location.
Install a cartridge in the source location, or
redirect the CHM to another location.
12
DESTINATION FULL. A
cartridge already exists in the
destination location.
Remove the cartridge from the destination, or
redirect the CHM to another location.
13
PUT MECH. FAILURE. The
CHM could not successfully
place a cartridge because of
mechanical problems.
Make sure there is nothing blocking the CHM
or the tape drives. If the error persists, contact
your service provider.
14
PICK MECH. FAILURE. The
CHM could not successfully
pick a cartridge because of
mechanical problems.
15 NO SRC ELEMENT; NO DEST
ELEM ENT. No data cartridge
magazine was installed at the
selected location.
Install a data cartridge magazine or redirect
the CHM.
16
17
CHM FULL BEFORE MOVE.
There was a cartridge in the
gripper when the operator
powered-on or reset the
library, or before a move
operation.
Remove the cartridge and put it back in the
cartridge magazine if you know where it goes.
Make sure the library and tape drives are not
being used by any host, then press
>5HVHW@ on
the operator panel. If the error persists,
contact your service provider.