Filter
Top Products
Configuration
Installation and Operation
69
Changing the control mode
1. Make sure the library is in the ready state (for example, no
hardware errors, the door is closed, and so on).
2. If security has been enabled, disable it. See page 60.
3. From the Main Menu, select Interface Menu.
4. From the Interface Menu, select Control Mode Menu.
5. Select the desired control mode. The current control mode is
indicated with an asterisk (*).
➤ Important When the library is in LCD Interface
mode or in one of the serial port modes, the
software application cannot control the CHM.
6. When the library displays a confirmation message that it has
changed the control mode, press
>(VFDSH@
to return to the
Interface Menu, and
>(VFD SH@
again to return to the Main Menu.