Filter
Top Products
Hardware Installation
Installation and Operation
19
Installing the slide rails into the rack
To install the slide rails into the rack:
1. Locate the mounting holes on the rack where you want to
install the library. Allow 1 to 2 inches (3 to 4 cm) minimum
clearance below the bottom mounting hole.
Note: If the rack does not have threaded holes, attach eight
of the ten clip nuts over the holes (see the following
figure).
2. Using a T-25 TORX driver and eight (four for each rail)
10-32 × pan head screws, attach, but do not tighten, the
slide rails to the rack (see the following figure).
12⁄