Filter
Top Products
99
Controlling the AR-3000R from an External Device
Applications
Recording
13: 0 (OFF)
14: 1 (ON)
→
While control signals are being input, the specified phrase
is recorded. When input of the control signal stops, recording
then ends.
fig.14-36e
* Recording does not start if there is a binary-specified phrase
that has already been recorded (the recording instruction is
disabled). When recording, either specify an empty phrase or
delete the existing phrase before recording the new one.
Additionally, in Binary Recording, since a make signal is
output from the CONT OUT port when a specified phrase has
already been recorded, this allows confirmation using a
connected external control device.
Playback
13: 1 (ON)
14: 0 (OFF)
→
The specified phrase is played back. Even when control
signals are input continuously, the phrase is played back one
time only and then ends.
fig.14-37e
* Playback does not begin if the binary-specified phrase is empty
(the playback instruction is disabled). When playing back,
specify a phrase that has already been recorded.
Timing Chart (Rec)
Trw
Tbrs
Tbrh
Tbrd
Tvrd
Tbred
Tvred
300
200
100
-
-
-
-
-
-
-
300
300
100
100
min max
(msec)
AUDIO OUTPUT
Busy Out
Port No.14
Tvred
Trw
Tbrs
Tbrh
Tbrd
Tvrd
Tbred
Binary Specification
Port No.1–11
: Play Pulse Width
: Binary Setup Time
: Binary Hold Time
: Busy Delay Time
: Audio Delay Time
: End Busy Delay Time
: End Audio Delay Time
Timing Chart (PLAY)
Tpw
Tbps
Tbph
Tbpd
Tvpd
Tvbd
(msec)
20
200
100
-
-
-
-
-
-
300
300
100
min max
Tvbd
Tpw
Tbps
Tbph
Tbpd
Tvpd
AUDIO OUTPUT
Busy Out
Port No.13
Binary Specification
Port No.1–11
: Play Pulse Width
: Binary Setup Time
: Binary Hold Time
: Busy Delay Time
: Audio Delay Time
: End Busy Delay Time
AR-3000R_e.book 99 ページ ２０１０年３月１８日 木曜日 午後２時６分