Filter
Top Products
100
Controlling the AR-3000R from an External Device
Erase
14: 1 (ON)
13: 1 (ON)
→
First, when ON is input to Port No. 14, and then ON is
input to Port No. 13, erasure of the specified phrase begins.
Erasure ends when the signal from the CONT OUT port
(confirming the presence or absence of the phrase) changes to
OFF.
* Erasure does not begin if the binary-specified phrase is empty
(the playback instruction is disabled). When erasing, specify a
phrase that has already been recorded.
fig.14-38e
* Tpdd: Play phrase output delay time is dependent on the card
used.
AR-3000R Settings
If a card in AR-2000 format is inserted in either slot A or B (or
both), the AR-3000R can be used only for playback, and it is
not possible to record phrases or make any settings (except
for card conversion). Also, if you insert a card in AR-2000
format into slot A or B (or both) while making settings
(except for card conversion), operation will halt with an error
message, and cannot be resumed until such cards are
removed. To record or edit cards in AR-2000 format on the
AR-3000R, follow the steps in “Card Convert” (p. 78).
Selecting the Control Input Mode
Select “BINARY REC” from the control input modes
(DIRECT PLAY/PROGRAM PLAY/BINARY PLAY/
BINARY REC).
* You cannot achieve Binary Recording merely by connecting a
device to the port. Be sure to set the control input mode to
match the method used for connecting to the ports.
Procedure for Setting the Control Input Mode
1.
Press the MODE button.
The MODE indicator lights up.
2.
Use the SELECT dial to choose “5.1 Control Input
Mode,” then press the dial.
3.
Turn the SELECT dial to choose “BINARY REC,” then
press the dial.
fig.14-g12e
4.
When the prompt appears on the screen, press the
ENTER button to enable the settings.
To quit without making the settings, use the SELECT dial to
choose “NO,” then press the ENTER button.
Once the settings have been made successfully, you’re
returned to the setting item selection screen.
5.
Press the MODE button.
This ends the setting process and returns you to the usual
screen.
* If you press the MODE button while making settings, a
message asking you to confirm that you want to exit the
setting process appears. Note that if you choose “YES,” then
press the ENTER button, you are returned to the usual screen,
and all setting changes you’ve made up to that point will be
discarded.
Timing Chart ( Delete)
Trdw
Tpds
Tpdh
Tprd
Tbds
Tbdh
Tbcd
Tpdd
100
50
50
0
200
20
-
-
-
-
-
-
-
-
250
2500 (typ.)
min max
(msec)
Tpdd
Trdw
Tpds Tpdh
Tprd
Tbds
Tbdh
Tbcd
Port No.13
Binary Specification
Port No.1–11
Port No.14
(the presence or absence
of phrases)
Control Out
: Delete Rec Pulse Width
: Delete Play Setup Time
: Delete Play Hold Time
: Delete Play Rec Delay Time
: Delete Binary Setup Time
: Delete Binary Hold Time
: Binary Phrase Output Delay Time
: Play Phrase Output Delay Time
AR-3000R_e.book 100ページ ２０１０年３月１８日 木曜日 午後２時６分