Filter
Top Products
121
Playing Two Units's Worth of Data on the Left and Right
Applications
* If you press the MODE button while making settings, a
message asking you to confirm that you want to exit the
setting process appears. Note that if you choose “YES,” then
press the ENTER button, you are returned to the usual screen,
and all setting changes you’ve made up to that point will be
discarded.
Operation Procedures
Dual Mono Playback Through Manual
Operation
You can perform manual playback, in the same way as for
ordinary stereo playback.
1.
Insert a card containing recorded information into a slot.
2.
Turn the SELECT dial to choose the phrase number to
play.
fig.18-g01e
* To switch between card slots A and B, press the SELECT dial.
* To switch between L (left) and R (right), press the ENTER
button.
3.
• Pressing the PLAY button plays back a phrase. During
playback of the phrase, the PLAY indicator lights up in
green.
* The phrase whose phrase number is highlighted is played back.
• Pressing the STOP button ends playback.
• During playback, you can choose the next song to play
(without stopping the phrase being played) by turning
the SELECT dial.
Please be aware that you cannot pause Dual Mono playback.
Dual Mono Playback Through Control
Input
You can perform playback through control input, in the same
way as for ordinary stereo playback.
The settings for control-input playback basically act
independently for each channel.
For more information about the operation of playback with
control input terminals, see also “Controlling the AR-3000R
from an External Device (Control Input)” (p. 85).
During Direct Playback
Odd-numbered phrases are output by direct playback from
output L (left), and even-numbered phrases are output by
direct playback from output R (right). The order of priority of
the control input connectors may vary depending on how
phrases are assigned to the control input terminals. To
facilitate understanding, the explanations in this section
assume that the assigned phrase numbers correspond to the
port numbers.
fig.18-02e (Monaural and Direct Charts)
When you send a Stop input signal, playback stops
simultaneously for the L and R channels.
* Input a trigger signal to the control signal.
* Do not simultaneously input more than one control input
allocated to the same output.
●
Normal Playback
ig.18-04e (Ordinary Playback Example 2)
• Because port Nos. 1 and 3 are allocated to output L,
depending on the port priority, playback of A0003 is
halted and A0001 is played.
• Because port No. 2 is allocated to output R, A0002
continues to be played back even during playback of
A0003 or A0001.
●
First-In Playback
fig.18-03e (Ordinary Playback Example 1)
• Because port Nos. 1 and 3 are allocated to output L,
depending on the port priority, signals input to 3 are not
valid.
• Because port No. 2 is allocated to output R, A0002 is
played back even during playback of A0001.
L ch
R ch
Port No.
Phrase
...
...
1
A0001
2
A0002
3
A0003 A0004
4
A0005
516
A0016
...
Output jack
LRLRL R
Port 1
Output R
Port 2
Port 3
Output L
A0003
A0002
A0003 Interrupted
A0001
Port 1
Output R
Port 2
Port 3
Output L
A0001
A0002
Ignored
AR-3000R_e.book 121ページ ２０１０年３月１８日 木曜日 午後２時６分