Filter
Top Products
91
Controlling the AR-3000R from an External Device
Applications
fig.14-19e
However, if no settings are made for Programs 2 through 5
when a control signal is input to the “EXCHANGE” port,
playback continues after returning to the beginning in
Program 1 (Reset operation).
fig.14-20e (Count Playback 3)
Also refer to “Operational Specifications of Control Input
Playback” (p. 85).
Important Note Regarding Power Outages and Similar
Situations
If due to a blackout or other cause the power to the AR-3000R
is cut during program playback, the program playback is
reset when the power is restored. In such instances, input
control signals to the INC, DEC, and EXCHANGE ports to
restore the program playback order.
fig.14-21e
Display Indications During
Program Playback
During program playback, the following appears in the
display.
fig.14-21ae
AR-3000R Settings
If a card in AR-2000 format is inserted in either slot A or B (or
both), the AR-3000R can be used only for playback, and it is
not possible to record phrases or make any settings (except
for card conversion). Also, if you insert a card in AR-2000
format into slot A or B (or both) while making settings
(except for card conversion), operation will halt with an error
message, and cannot be resumed until such cards are
removed. To record or edit cards in AR-2000 format on the
AR-3000R, follow the steps in “Card Convert” (p. 78).
Selecting the Control Input Mode
Select “PROGRAM PLAY” from the control input modes
(DIRECT PLAY/PROGRAM PLAY/BINARY PLAY/
BINARY REC).
* You cannot achieve control input playback merely by
connecting a device to the port. Be sure to set the control input
mode to match the method used for connecting to the ports.
Procedure for Setting the Control Input Mode
1.
Press the MODE button.
The MODE indicator lights up.
2.
Use the SELECT dial to choose “5.1 Control Input
Mode,” then press the dial.
3.
Turn the SELECT dial to choose “PROGRAM PLAY,”
then press the dial.
fig.14-g06e
4.
When the prompt appears on the screen, press the
ENTER button to enable the settings.
To quit without making the settings, use the SELECT dial to
choose “NO,” then press the ENTER button.
Once the settings have been made successfully, you’re
returned to the setting item selection screen.
5.
Press the MODE button.
This ends the setting process and returns you to the usual
screen.
* If you press the MODE button while making settings, a
message asking you to confirm that you want to exit the
setting process appears. Note that if you choose “YES,” then
press the ENTER button, you are returned to the usual screen,
and all setting changes you’ve made up to that point will be
discarded.
AUDIO OUTPUT
START Port
EXCHANGE Port
Program 1
No. 001
Program 2
No. 001
AUDIO OUTPUT
START Port
EXCHANGE Port
Program Play 1
No. 001
Program Play 1
No. 001
START Port
AUDIO OUTPUT
INC Port
DEC Port
No. 002 → No. 003
No. 004 → No. 003
EXCHANGE Port
Program 1
No. 001
Program 2
No. 001
No.
003
No.
003
Program 1 → Program 2
Program Number
Registered Phrase No.
Remaining Time/Elapsed Time
Playback order
AR-3000R_e.book 91 ページ ２０１０年３月１８日 木曜日 午後２時６分