Filter
Top Products
127
Other Useful Functions During Phrase Playback
Applications
2.
Use the SELECT dial to choose “9.3 Equalizer,” then
press the dial.
fig.20-g03e
3.
Turn the SELECT dial to set Switch to “ON,” then press
the dial.
4.
Turn the SELECT dial to set the Low Freq (to 200 or 400
Hz), then press the dial.
5.
Turn the SELECT dial to set the Low Gain (at a value
from -12 dB to +12 dB), then press the dial.
6.
Turn the SELECT dial to set High Freq (to 3 or 6 kHz),
then press the dial.
7.
Turn the SELECT dial to set the High Gain (at a value
from -12 dB to +12 dB), then press the dial.
8.
If distortion is a problem, turn the SELECT dial to make
the setting for Attenuation (-12 dB to 0 dB), then press the
dial.
You can play back the selected phrase by pressing the PLAY
button. This makes it possible to make the setting while
monitoring the actual sound quality.
9.
When the prompt appears on the screen, press the
ENTER button to enable the settings.
To quit without making the settings, use the SELECT dial to
choose “NO,” then press the ENTER button.
When you’re finished making the setting, the display returns
to the setting item selection screen.
10.
Press the MODE button.
This ends the setting process and returns you to the usual
screen.
* While making the settings, you can go back to the previous
entry position (highlighted) by using the PAUSE(BACK)
button.
* Pressing the MODE button while making the setting displays
a prompt asking you whether you want to quit making the
setting. Note that choosing “YES” and pressing the ENTER
button returns you to the usual screen, discarding any
settings made up to that point.
Keeping the Output Volume
Unchanged (Output Volume
Thru)
This deactivates the OUTPUT VOLUME knob and keeps the
output volume level unchanged to prevent accidental
operation.
* The OUTPUT VOLUME knob can still be used to adjust the
headphones volume and MONO OUT (Control Input/Output
Terminals) even when Volume Thru is set to “ON.”
OFF:
The Output Volume control is effective.
ON:
The Output Volume control is deactivated.
When Volume Thru is set to “ON,” the volume is fixed at the
level obtained when the control is centered (that is, when
positioned at 12 o’clock).
Procedure for Making the Output Volume Thru
Setting
1.
Press the MODE button.
The MODE indicator lights up.
2.
Use the SELECT dial to choose “9.4 Output Vol. Thru,”
then press the dial.
3.
Turn the SELECT dial to choose Volume Thru (OFF or
ON), then press the dial.
fig.20-g04e
4.
When the prompt appears on the screen, press the
ENTER button to enable the settings.
To quit without making the settings, use the SELECT dial to
choose “NO,” then press the ENTER button.
When you’re finished making the setting, the display returns
to the setting item selection screen.
5.
Press the MODE button.
This ends the setting process and returns you to the usual
screen.
* Pressing the MODE button while making the setting displays
a prompt asking you whether you want to quit making the
setting. Note that choosing “YES” and pressing the ENTER
button returns you to the usual screen, discarding any
settings made up to that point.
AR-3000R_e.book 127ページ ２０１０年３月１８日 木曜日 午後２時６分