Filter
Top Products
38
The Display
Making the Display Go Dark
You can make the display go dark automatically after a certain period of
time has elapsed following the last operation in the phrase playback screen.
You can set the time until the display goes dark (Sleep Time) to anything
from 30 seconds to 59 minutes 59 seconds.
When the unit is in continuous use for long periods, such as on systems that
run 24 hours a day, this can help protect the display from deterioration. Set
it to match your usage conditions.
When the display is dark, the EZ SETUP indicator flashes.
When the display is dark, you can make it appear again quickly by pressing
any of the six buttons on the front panel.
Procedure for Making the Display Go Dark
1
Press the MODE button.
The MODE indicator lights up.
2
Use the SELECT dial to choose “9.6 Display Sleep,” then press
the dial.
3
Turn the SELECT dial to choose Display Sleep (ON), then
press the dial.
4
Turn the SELECT dial to make the setting for Sleep Time (00m
30sec to 59m 59sec), then press the dial.
fig.08-g05e
5
When the prompt appears on the screen, press the ENTER
button to enable the settings.
To quit without making the settings, use the SELECT dial to choose “NO,”
then press the ENTER button.
When you’re finished making the setting, the display returns to the setting
item selection screen.
AR-3000R_e.book 38 ページ ２０１０年３月１８日 木曜日 午後２時６分