Filter
Top Products
94
Controlling the AR-3000R from an External Device
The binary-specified phrase is played back repeatedly.
Phrases are played back repeatedly as long as the START
signal is input continuously.
With START signals being input continuously, playback of
phrases may be started by binary specification.
When the Start port control signal is changed to OFF,
playback tops after completion of the phrase currently being
played.
Newly input START signals during playback of a phrase are
disregarded.
Level: OFF, Edge: ON
fig.14-28e
The binary-specified phrase is played back only once.
When a START signal is input again during playback of a
phrase, the phrase currently being played back is stopped,
and playback of the specified phrase begins.
Even when START signals are input continuously, the phrase
is played back only once and then stopped. Since a phrase is
played back by the instrument detecting the start when the
port switches on from the off status, be sure to make the
control signal to the Start connector OFF after playback of the
phrase is finished.
Level: ON, Edge: ON
fig.14-29e
The binary-specified phrase is played back repeatedly.
Phrases are played back repeatedly as long as the START
signal is input continuously.
With START signals being input continuously, playback of
phrases may be started by binary specification.
When the Start port control signal is changed to OFF,
playback tops after completion of the phrase currently being
played.
When a START signal is input again during playback of a
phrase, the phrase currently being played back is stopped,
and playback of the specified phrase begins.
AR-3000R Settings
If a card in AR-2000 format is inserted in either slot A or B (or
both), the AR-3000R can be used only for playback, and it is
not possible to record phrases or make any settings (except
for card conversion). Also, if you insert a card in AR-2000
format into slot A or B (or both) while making settings
(except for card conversion), operation will halt with an error
message, and cannot be resumed until such cards are
removed. To record or edit cards in AR-2000 format on the
AR-3000R, follow the steps in “Card Convert” (p. 78).
Selecting the Control Input Mode
Select “BINARY PLAY” from the control input modes
(DIRECT PLAY/PROGRAM PLAY/BINARY PLAY/
BINARY REC).
* You cannot achieve control input playback merely by
connecting a device to the port. Be sure to set the control input
mode to match the method used for connecting to the ports.
Procedure for Setting the Control Input Mode
1.
Press the MODE button.
The MODE indicator lights up.
2.
Use the SELECT dial to choose “5.1 Control Input
Mode,” then press the dial.
3.
Turn the SELECT dial to choose “BINARY PLAY,” then
press the dial.
fig.14-g10e
4.
When the prompt appears on the screen, press the
ENTER button to enable the settings.
To quit without making the settings, use the SELECT dial to
choose “NO,” then press the ENTER button.
Once the settings have been made successfully, you’re
returned to the setting item selection screen.
5.
Press the MODE button.
This ends the setting process and returns you to the usual
screen.
* If you press the MODE button while making settings, a
message asking you to confirm that you want to exit the
setting process appears. Note that if you choose “YES,” then
press the ENTER button, you are returned to the usual screen,
and all setting changes you’ve made up to that point will be
discarded.
AUDIO OUTPUT
Binary Specification
Port 1–11
START Port
A0001 A0002
A0002
A0001
A0003
A0003
A0001 Interrupted
Disabled
AUDIO OUTPUT
Binary Specification
Port 1–11
START Port
A0001
A0001 A0002
A0002
A0001
A0003 A0004
A0004
A0003
A0003 Interrupted
AR-3000R_e.book 94 ページ ２０１０年３月１８日 木曜日 午後２時６分