Filter
Top Products
109
Controlling the AR-3000R Using MIDI Signals (MIDI Control)
Applications
MIDI Implementation and MIDI Implementation Chart
→
p.
139 through p. 145
Procedure for Making the Receive Message
Setting
1.
Press the MODE button.
The MODE indicator lights up.
2.
Use the SELECT dial to choose “6.6 MIDI RX Message,”
then press the dial.
3.
Turn the SELECT dial to choose the Note On Velocity
(OFF or ON), then press the dial.
fig.16-g07e
4.
Turn the SELECT dial to choose the Panpot (OFF or ON),
then press the dial.
5.
Turn the SELECT dial to choose the Expression (OFF or
ON), then press the dial.
6.
When the prompt appears on the screen, press the
ENTER button to enable the settings.
To quit without making the setting, use the SELECT dial to
choose “NO,” then press the ENTER button.
Once the settings have been successfully modified, you’re
returned to the setting item selection screen.
7.
Press the MODE button.
This ends the setting process and returns you to the usual
screen.
* While making the settings, you can go back to the previous
entry position (highlighted) by using the PAUSE (BACK)
button.
* If you press the MODE button while making settings, a
message asking you to confirm that you want to exit the
setting process appears. Note that if you choose “YES,” then
press the ENTER button, you are returned to the usual screen,
and all setting changes you’ve made up to that point will be
discarded.
Operation Procedures
When you have finished making the settings, send MIDI
signals from the external MIDI instrument. When messages
are received, the unit starts playing back the phrases.
MIDI Note Out
If MIDI Note Out is set to “ON,” then when an audio phrase
is played back, the MIDI Note Number On/Off signals set in
the MIDI Note Map (p. 107) are output from the MIDI OUT
connector.
It’s possible to use this signal to control a number of AR-
3000R units.
* If multiple note numbers are selected for the playback phrase,
only the on or off signal for the lowest note number is output.
Output is on the MIDI channel set with the MIDI receive
channel (p. 108).
If the MIDI receive channel is set to:
•
OFF:
There is no output.
•
1 through 16:
Only the MIDI signals received on the
selected channel are output.
•
ALL:
Output is on channel 1.
* When you are controlling a number of AR-3000R units using
note Numbers, set the MIDI note trigger (p. 108) for the
controlled AR-3000R to Trigger.
* Even when MIDI phrases are played back, note number on/off
signals are not output.
Procedure for Making the MIDI Note Out
Channel Settings
1.
Press the MODE button.
The MODE indicator lights up.
2.
Use the SELECT dial to choose “6.3 MIDI Note Out,”
then press the dial.
3.
Turn the SELECT dial to choose the MIDI Note Output
(ON or OFF), then press the dial.
fig.16-g09e
4.
When the prompt appears on the screen, press the
ENTER button to enable the settings.
To quit without making the settings, use the SELECT dial to
choose “NO,” then press the ENTER button.
Once the settings have been successfully modified, you’re
returned to the setting item selection screen.
5.
Press the MODE button.
This ends the setting process and returns you to the usual
screen.
* If you press the MODE button while making settings, a
message asking you to confirm that you want to exit the
setting process appears. Note that if you choose “YES,” then
press the ENTER button, you are returned to the usual screen,
and all setting changes you’ve made up to that point will be
discarded.
AR-3000R_e.book 109ページ ２０１０年３月１８日 木曜日 午後２時６分