Filter
Top Products
55
Modifying Recorded Phrases (Phrase Settings)
Applications
4.
Turn the SELECT dial to set the Volume (from 10% to
100%), then press the dial.
fig.11-g01e
You can play back the selected phrase by pressing the PLAY
button. This makes it possible to make the setting while
monitoring the actual volume level.
You can change the selected phrase by pressing the BACK
button and moving the cursor to the phrase number.
5.
When the prompt appears on the screen, press the
ENTER button to enable the settings.
To quit without making the settings, use the SELECT dial to
choose “NO,” then press the ENTER button.
Once the settings have been successfully modified, you’re
returned to the setting item selection screen.
6.
Press the MODE button.
This ends the setting process and returns you to the usual
screen.
* If you press the MODE button while making settings, a
message asking you to confirm that you want to exit the
setting process appears. Note that if you choose “YES,” then
press the ENTER button, you are returned to the usual screen,
and all setting changes you’ve made up to that point will be
discarded.
Delay Time (00s 00f to 59s 29f)
This sets the time until phrase playback starts.
* The frame display varies according to the setting for the MIDI
Time Code (MTC) frame rate.
fig.11-01e
If you’re using Busy Out signals to start an amp or the like, inserting
a delay time into the phrase that corresponds to the amp start time
(that it, the time until sound is produced) can help prevent drop-out
at the beginning of the phrase at the time of playback.
Busy Out
→
p. 102
Procedure for Setting the Delay Time
1.
Use the SELECT dial to choose the phrase whose setting
you want to change.
2.
Press the MODE button.
The MODE indicator lights up.
3.
Use the SELECT dial to choose “1.2 Delay Time,” then
press the dial.
You can reselect a phrase whose setting you want to change
by pressing the PAUSE (BACK) button. The entry position
(highlighted) moves to the phrase selection, so turn the
SELECT dial to reselect card A or B and the phrase number,
then press the dial.
4.
Turn the SELECT dial to set the Delay Time, then press
the dial.
fig.11-g02e
5.
When the prompt appears on the screen, press the
ENTER button to enable the settings.
To quit without making the settings, use the SELECT dial to
choose “NO,” then press the ENTER button.
Once the settings have been successfully modified, you’re
returned to the setting item selection screen.
6.
Press the MODE button.
This ends the setting process and returns you to the usual
screen.
* If you press the MODE button while making settings, a
message asking you to confirm that you want to exit the
setting process appears. Note that if you choose “YES,” then
press the ENTER button, you are returned to the usual screen,
and all setting changes you’ve made up to that point will be
discarded.
Playback Point (Start and End)
These determine where phrase playback is to start and end.
fig.11-02e
* You can automatically seek and set points at the locations of
silent portions (AUTO).
Phrase
Delay Time
Playback start
Playback instruction
(Play button, control
input, etc.)
Phrase
Start
End
Playback passage
AR-3000R_e.book 55 ページ ２０１０年３月１８日 木曜日 午後２時６分