Filter
Top Products
118
Controlling the AR-3000R Using MIDI Signals (MIDI Control)
MTC Offset Setting
This adjusts the timing when you are using MTC to
synchronize operation of the unit and an external MIDI
instrument.
Settings When Synchronizing Operation of the Unit to the
MIDI Time Code from an External MIDI Instrument
When you’re operating the unit on receiving the MIDI Time
Code from an external MIDI instrument, you can effect
playback on the unit at any time you want.
For instance, if you want to play back a phrase when the
MTC time on the external MIDI instrument is
“01h00m00s00f,” set the offset to “01h00m00s00f.”
Settings When Synchronizing an External MIDI
Instrument to the MIDI Time Code from the Unit
When you’re operating an external instrument on receiving
the MIDI Time Code from the unit, you can effect playback
on the external instrument at any time you want.
For instance, if you want to play back a phrase on the unit,
then after the elapse of “00h00m10s00f” effect playback on
the external MIDI instrument at “00h00m00s00f,” set the
offset to “23h59m50s00f.”
“00h00m00s00f” - “00h00m10s00f” = “23h59m50s00f”
When the calculated time value is negative, add
“24h00m00s00f.”
Procedure for Setting the MTC Offset
1.
Press the MODE button.
2.
Use the SELECT dial to choose “6.9 MTC,” then press the
dial.
3.
Press the SELECT dial and advance the entry location
(highlighted) to “Offset.”
4.
Turn the SELECT dial to set the offset (time), then press
the dial.
Each press of the BACK button moves the cursor (highlighted) in the
sequence of f
→
s
→
m
→
h.
5.
When the prompt appears on the screen, press the
ENTER button to enable the settings.
To quit without making the settings, use the SELECT dial to
choose “NO,” then press the ENTER button.
Once the settings have been successfully modified, you’re
returned to the setting item selection screen.
6.
Press the MODE button.
This ends the setting process and returns you to the usual
screen.
* While making the settings, you can go back to the previous
entry location (highlighted) by pressing the PAUSE (BACK)
button.
* If you press the MODE button while making settings, a
message asking you to confirm that you want to exit the
setting process appears. Note that if you choose “YES,” then
press the ENTER button, you are returned to the usual screen,
and all setting changes you’ve made up to that point will be
discarded.
AR-3000R_e.book 118ページ ２０１０年３月１８日 木曜日 午後２時６分