Filter
Top Products
79
Making Settings and Edits for Individual Cards
Applications
to eliminate the cause of the error. (For information on error-
causing items and remedies, refer to “Conversion Error List”
(p. 80).)
• If you are using the AR-3000R to perform recording or
editing on a card used on an AR-2000, we recommend
making settings only for items that remain effective
without change when the card is converted to AR-2000
format.
■
Conversion Using a Single Card and Conversion Using
Two Cards
With Card Convert, in addition to converting a single card
(the card itself), you can perform conversion while copying
one card (the source) to another card (the destination).
We recommend converting using two cards when you want
to leave what is on the card unconverted. When you perform
conversion using two cards, insert the copy-source card into
slot A and the copy-destination card into slot B.
When you are converting using two cards, the copy-source
card and the copy-destination card don’t have to be the same
size (capacity), but you can perform Card Convert only when
the usable space on the destination card is larger than the
space used on the source card.
When you convert data in AR-2000 format to AR-3000
format, the amount of data after conversion increases
slightly. This means that even if you are converting the same
card (conversion using a single card) or two cards that have
the same capacity (conversion using two cards), it may not be
possible to perform conversion if there is no more free space
or if there is little free space remaining. If this happens, then
reduce the amount of data on the copy-source card, such as
by deleting unneeded phrases.
Procedure for Card Convert
1.
Press the MODE button.
The MODE indicator lights up.
2.
Use the SELECT dial to choose “4.7 Card Convert,” then
press the dial.
3.
Turn the SELECT dial to choose the Convert, then press
the dial.
fig.12-g05e
•
AR-3000
→
AR-2000:
This converts a card in AR-3000
format to AR-2000 format.
•
AR-2000
→
AR-3000:
This converts a card in AR-2000
format to AR-3000 format.
4.
Turn the SELECT dial to choose the Card you want to
convert, then press the dial.
fig.12-g06e
•
A
→
A:
This converts a single card (the card itself).
•
A
→
B:
This converts card A (the copy source) to card B
(the copy destination).
* Be sure to insert the cards into the correct slots.
5.
When the prompt appears on the screen, press the
ENTER button to enable the settings.
To quit without making the settings, use the SELECT dial to
choose “NO,” then press the ENTER button.
When the operation ends, the display returns to the setting
item selection screen.
6.
Press the MODE button.
This ends the setting process and returns you to the usual
screen.
* While making the settings, you can go back to the previous
entry position (highlighted) by using the PAUSE (BACK)
button.
* Pressing the MODE button while making the setting displays
a prompt asking you whether you want to quit making the
setting. Note that choosing “YES” and pressing the ENTER
button returns you to the usual screen, discarding any
settings made up to that point.
AR-3000R_e.book 79 ページ ２０１０年３月１８日 木曜日 午後２時６分