Filter
Top Products
117
Controlling the AR-3000R Using MIDI Signals (MIDI Control)
Applications
Device-specific ID (MIDI Device ID)
Settings
This sets the MIDI device ID (from 1 through 32). When you
are controlling an external MIDI instrument using MMC and
MTC, you need to set both devices to matching device ID
numbers. Check the device ID of the connected external
MIDI instrument, then set the unit to the same device ID.
Procedure for Setting the MIDI Device ID
For setting procedure, refer to p. 114.
MMC mode (OFF/MASTER/SLAVE)
This sets the MMC Mode to “MASTER.”
OFF:
MMC information is not sent or received.
MASTER:
MMC information is sent. The unit becomes the
master of the external MIDI instrument.
SLAVE:
MMC information is received. The unit becomes the
slave of the external MIDI instrument.
Procedure for Setting the MMC Mode
For setting procedure, refer to p. 111.
Selecting the Sync Source (INTERNAL
or MTC)
This sets the Sync Source to “INTERNAL.”
INTERNAL:
The slave device operates according to the AR-
3000R’s internal time control. Select this to make the unit the
master.
MTC:
The unit operates according to MIDI time code
information from the master device. Select this to make the
unit the slave.
Note that when Sync Source is set to “MTC,” there is no
operation unless MTC information is input from the external
MIDI instrument.
Procedure for Setting the Sync Source
For setting procedure, refer to p. 111.
Selecting Sync Out (OFF or MTC)
This sets Sync Out to “MTC.”
OFF:
MIDI time codes are not sent.
MTC:
MIDI time codes are sent. Select this when you are
operating a slave device using the unit’s MTC.
Procedure for Setting Sync Out
1.
Press the MODE button.
The MODE indicator lights up.
2.
Use the SELECT dial to choose “6.9 MTC,” then press the
dial.
3.
Press the SELECT dial to advance the input location
(highlighted) to “Sync Out.”
4.
Turn the SELECT dial to set Sync Out to “MTC,” then
press the dial.
fig.16-g23e
• If you are continuing by making the setting for “MTC
Type,” proceed to step 4 of the procedure for setting the
MTC Type (p. 115).
To finish making the setting, press the ENTER button.
5.
When the prompt appears on the screen, press the
ENTER button to enable the settings.
To quit without making the settings, use the SELECT dial to
choose “NO,” then press the ENTER button.
Once the settings have been successfully modified, you’re
returned to the setting item selection screen.
6.
Press the MODE button.
This ends the setting process and returns you to the usual
screen.
* While making the settings, you can go back to the previous
entry position (highlighted) by using the PAUSE (BACK)
button.
* If you press the MODE button while making settings, a
message asking you to confirm that you want to exit the
setting process appears. Note that if you choose “YES,” then
press the ENTER button, you are returned to the usual screen,
and all setting changes you’ve made up to that point will be
discarded.
Selecting the MTC Type (30/29N/29D/
25/24)
This selects the MTC type (frame rate).
Check the specifications of the connected external MIDI
instrument, then make the settings.
Types of MTC (Frame Rates)
→
p. 112
Procedure for Setting the MTC Type
For setting procedure, refer to p. 115.
Operation Procedures
When you have finished making the settings, play back a
phrase on the unit. The connected slave device carries out
synchronized playback.
AR-3000R_e.book 117ページ ２０１０年３月１８日 木曜日 午後２時６分