Filter
Top Products
89
Controlling the AR-3000R from an External Device
Applications
Procedure for Assigning Phrases
1.
Press the MODE button.
The MODE indicator lights up.
2.
Use the SELECT dial to choose “5.2 Direct Play,” then
press the dial.
3.
Press the SELECT dial to advance the input location
(highlighted) to “No. 1.”
4.
Turn the SELECT dial to choose the number of the
control input port that is to be set, then press the dial.
fig.14-g03e
•
Nos. 1-16:
Port Nos. 1 through No. 16
•
END:
This quits making the settings.
•
RESET:
Restores the settings at the time the card was
formatted.
•
CLEAR:
Erases all settings.
5.
Turn the SELECT dial to choose the card containing the
phrase you want to assign to the port, then press the dial.
fig.14-g04e
• PLAY: Causes this connector to perform the same action
as that resulting from pressing the PLAY button on the
front panel.
• -----: Selected when no phrase is set to the control input
port.
Turn the SELECT dial to choose the phrase to assign to the
port, then press the dial.
6.
Repeat steps 4 and 5 to assign the rest of the phrases.
7.
To quit assigning phrases, turn the SELECT dial in step 4
to choose “END,” then press the dial.
fig.14-g05e
8.
When the prompt appears on the screen, press the
ENTER button to enable the settings.
To quit without making the settings, use the SELECT dial to
choose “NO,” then press the ENTER button.
Once the settings have been made successfully, you’re
returned to the setting item selection screen.
9.
Press the MODE button.
This ends the setting process and returns you to the usual
screen.
* While making the settings, you can go back to the previous
entry position (highlighted) by using the PAUSE (BACK)
button.
* If you press the MODE button while making settings, a
message asking you to confirm that you want to exit the
setting process appears. Note that if you choose “YES,” then
press the ENTER button, you are returned to the usual screen,
and all setting changes you’ve made up to that point will be
discarded.
Playing Back Phrases in the
Order They Are Selected
(Program Playback)
What is Program Playback?/
Uses and Applications
You can have the group of preset phrases play back in the
order they are selected by inputting a control signal to the
START port.
With program playback, you can register up to a maximum
of 100 phrases in each of the five patterns of Programs 1
through 5.
Since the order and duration of the phrases is predetermined,
this is a convenient option when you have only one contact,
such as a timer or switch, with which to trigger this action.
fig.14-15e
Program 1
1 A0001
2 A0005
No. Phrase
3 A0004
:
:
100 A0100
START signal
START signal
START signal
START signal
Program 2
1 B0002
2 B0003
No. Phrase
3 A0006
::
100 B0088
START signal
START signal
START signal
START signal
Program 5
1 A0020
2 B0010
No. Phrase
3 A0021
:
:
100 B0011
START signal
START signal
START signal
START signal
EXCHANGE signal
:
:
:
AR-3000R_e.book 89 ページ ２０１０年３月１８日 木曜日 午後２時６分