Filter
Top Products
70
Modifying Recorded Phrases (Phrase Settings)
* Only phrases that can be executed are displayed.
4.
Turn the SELECT dial to set the split point (time), then
press the dial.
fig.11-g29e
You can set the points while listening to the audio by using
the SCRUB playback mode (p. 54). Also, you can use TO (to
split point) and FROM (from split point) to listen to audio for
a fixed time before and after the split point.
5.
Turn the SELECT dial to choose the card for write
destination 1, then press the dial.
fig.11-g30e
* If a card is inserted into either slot A or slot B, the entry
location (highlighted) advances to the phrase number.
Turn the SELECT dial to choose the phrase for write
destination 1, then press the dial.
* Only phrases that can be executed are displayed.
6.
Turn the SELECT dial to choose the card for write
destination 2, then press the dial.
fig.11-g31e
* If a card is inserted into either slot A or slot B, the entry
location (highlighted) advances to the phrase number.
Turn the SELECT dial to choose the phrase for write
destination 2, then press the dial.
* Only phrases that can be executed are displayed.
7.
When the prompt appears on the screen, press the
ENTER button to enable the settings.
To quit without making the settings, use the SELECT dial to
choose “NO,” then press the ENTER button.
Once the settings have been successfully modified, you’re
returned to the setting item selection screen.
8.
Press the MODE button.
This ends the setting process and returns you to the usual
screen.
* While making the settings, you can go back to the previous
entry location (highlighted) by pressing the PAUSE (BACK)
button.
* If you press the MODE button while making settings, a
message asking you to confirm that you want to exit the
setting process appears. Note that if you choose “YES,” then
press the ENTER button, you are returned to the usual screen,
and all setting changes you’ve made up to that point will be
discarded.
Joining Phrases (Phrase
Combine)
This joins two phrases, creating a single phrase.
fig.11-20e (Phrase Join)
* Phrase Combine cannot be executed unless the RDAC-Grade,
RDAC-Mode, and recording type are the same for both
phrases.
You cannot make these settings for MODE2 phrases.
Procedure for Joining Phrases
1.
Press the MODE button.
The MODE indicator lights up.
2.
Use the SELECT dial to choose “3.5 Phrase Combine,”
then press the dial.
3.
Turn the SELECT dial to choose the card containing the
first phrase to join (Src1), then press the dial.
fig.11-g32e
* If a card is inserted into either slot A or slot B, the entry
location (highlighted) advances to the phrase number.
Turn the SELECT dial to choose the first phrase to join (Src1),
then press the dial.
* Only phrases that can be executed are displayed.
4.
Turn the SELECT dial to choose the card containing the
second phrase to join (Src2), then press the dial.
fig.11-g33e
* If a card is inserted into either slot A or slot B, the entry
location (highlighted) advances to the phrase number.
Turn the SELECT dial to choose the second phrase to join
(Src2), then press the dial.
* Only phrases that can be executed are displayed.
Destination 1 Destination 2
Phrase1
Phrase 2
One phrase
Phrase 3
Src 1 Src 2
AR-3000R_e.book 70 ページ ２０１０年３月１８日 木曜日 午後２時６分