Filter
Top Products
57
Modifying Recorded Phrases (Phrase Settings)
Applications
* If you press the MODE button while making settings, a
message asking you to confirm that you want to exit the
setting process appears. Note that if you choose “YES,” then
press the ENTER button, you are returned to the usual screen,
and all setting changes you’ve made up to that point will be
discarded.
Repeat Play (Repeat, Repeat
Interval)
This makes the settings for repeated playback of a phrase.
Repeat passage:
This is the passage set with the playback
points (described earlier).
Repeat:
This sets the number of times playback is repeated.
(For example, when the number of repetitions is set to five
times, the phrase is played back a total of six times.) When
the number of repetitions is set to ON, playback repeats
endlessly.
Repeat Interval:
This sets the playback interval as a time
value.
fig.11-04e
Procedure for Making Repeat Play Settings
1.
Use the SELECT dial to choose the phrase whose setting
you want to change.
2.
Press the MODE button.
The MODE indicator lights up.
3.
Use the SELECT dial to choose “1.4 Repeat Play,” then
press the dial.
You can reselect a phrase whose setting you want to change
by pressing the PAUSE (BACK) button. The entry position
(highlighted) moves to the phrase selection, so turn the
SELECT dial to reselect card A or B and the phrase number,
then press the dial.
4.
Turn the SELECT dial to choose Repeat (OFF/ON/1 to
99), then press the dial.
fig.11-g04e
Turn the SELECT dial to set the Repeat Interval (from 00 m
00 s to 59 m 59 s), then press the dial.
* The number of the repeat interval can be set only when repeat
“ON” or “1–99” is selected.
5.
When the prompt appears on the screen, press the
ENTER button to enable the settings.
To quit without making the settings, use the SELECT dial to
choose “NO,” then press the ENTER button.
Once the settings have been successfully modified, you’re
returned to the setting item selection screen.
6.
Press the MODE button.
This ends the setting process and returns you to the usual
screen.
* While making the settings, you can go back to the previous
entry location (highlighted) by pressing the PAUSE (BACK)
button.
* If you press the MODE button while making settings, a
message asking you to confirm that you want to exit the
setting process appears. Note that if you choose “YES,” then
press the ENTER button, you are returned to the usual screen,
and all setting changes you’ve made up to that point will be
discarded.
Loop Play (Loop, Loop 1,
Loop 2, Crossfade Time)
This makes the setting for loop playback of the desired
passage of a phrase. Loop Playback starts at the start point
(playback point), then after looping the specified number of
times, playback ends at the end point (playback point).
Loop:
This sets the number of times playback is looped. (For
example, when the number of loops is set to five times, the
looped phrase is played back a total of six times.) When the
number of loops is set to Endless, playback loops endlessly.
Loop 1:
This specifies the return point for looping.
Loop 2:
This specifies the repeat point for looping.
Crossfade Time: This adjusts the junction during loop
playback. Longer times make for progressively greater
smoothness.
fig.11-05e
Loop Play is not possible when in the Dual Mono mode.
You cannot make these settings for MODE2 phrases.
When the number of loops is set to Endless, playback stops
approximately 50 days after the loop begins.
Phrase1 Phrase1
Repeat Interval
Phrase
Loop 1
Loop 2
Loop passage
AR-3000R_e.book 57 ページ ２０１０年３月１８日 木曜日 午後２時６分