Filter
Top Products
45
Recording Audio
Basic Operations
3
Turn the SELECT dial to choose RDAC-Grade (ANNOUNCE,
LONG2, LONG1, STANDARD, HIGH, or S-HIGH), then press
the ENTER button.
fig.09-g06e
* Pressing the PLAY button or the PAUSE button instead of the ENTER button
starts recording without locking in the setting.
* Please be aware that if you press the SELECT dial instead of the ENTER button, the
setting is not confirmed.
• The display of remaining time on the card available for recording
changes according to the selected RDAC-Grade.
• Next, if you’re making the setting for “RDAC-Mode”, you can proceed
to step 2 of the procedure for setting the RDAC-Mode.
RDAC-Mode (Signal Processing System)
The RDAC-Mode is a type of digital data processing system for recording.
On the AR-3000R, you can choose from among five types of modes.
fig.09-03e (RDAC Mode)
“H-LINEAR” enables recording at the highest sound quality, but uses the
most space on the card. “MODE1” uses up the least card space, and is suited
to long recording times. Select an RDAC-Mode that matches the
circumstances of use.
• If the type of card does not provide the recording time you want, change
the RDAC-Mode or RDAC-Grade setting to use less card capacity, then
perform recording again.
• Depending on the card type, an error may appear or recording may
stop. If this happens, change the RDAC-Mode or RDAC-Grade setting to
use less card capacity, then perform recording again.
H-LINEAR :
LINEAR :
MODE3 :
MODE2 :
MODE1 :
24 bit PCM Recording
16 bit PCM Recording
About 2.5 times the recording of Linear
More than 2.5 times the recording of Linear
About 4 times the recording of Linear
Sound
quality
Amount of card
memory consumed
High
Large
Small
* 1
“Card-specific Recording
Time Chart” → p. 134
“Error Messages” → p. 132
AR-3000R_e.book 45 ページ ２０１０年３月１８日 木曜日 午後２時６分