Filter
Top Products
3-1
Chapter 3
Remote Programming
Title Page
3-1. INTRODUCTION................................................................................3-3
3-2. CAPABILITIES ...................................................................................3-3
3-3. BUS SET-UP PROCEDURE...............................................................3-3
3-4. AN OVERVIEW OF REMOTE OPERATION...................................3-4
3-5. A NOTE ABOUT EXAMPLES...........................................................3-6
3-6. DEVICE-DEPENDENT COMMAND SET ........................................3-6
3-7. Bn (Offset Commands) ....................................................................3-9
3-8. Cn (Calibration Commands) ............................................................3-9
3-9. Dn (Display Commands)..................................................................3-9
3-10. Fn (Function Commands) ................................................................3-10
3-11. Get Commands.................................................................................3-10
3-12. G0 (Get Instrument Configuration)..................................................3-12
3-13. G1 (Get SRQ Mask).........................................................................3-12
3-14. G2 (Get Calibration Prompt)............................................................3-12
3-15. G3 (Get User-Defined Message)......................................................3-13
3-16. G4 (Get Calibration Status)..............................................................3-13
3-17. G5 (Get IAB Status).........................................................................3-14
3-18. G6 (Get YW Status).........................................................................3-14
3-19. G7 (Get Error Status) .......................................................................3-14
3-20. G8 (Get Instrument Identification)...................................................3-15
3-21. N (Numeric Entry Command)..........................................................3-15
3-22. Put Commands .................................................................................3-15
3-23. P0 (Put Instrument Configuration)...................................................3-15
3-24. P1 (Put SRQ Mask)..........................................................................3-16
3-25. P2 (Put Calibration Value)..............................................................3-16
3-26. P3 (Put User-Defined Message)......................................................3-17
3-27. Rn (Range Commands)....................................................................3-17
3-28. Sn (Reading Rate Commands).........................................................3-17
3-29. Tn (Trigger Mode Commands) ........................................................3-18
3-30. Wn (Terminator Commands) ...........................................................3-19
3-31. X0 (Clear Error Register Command) ...............................................3-19
3-32. Yn (Suffix Commands)....................................................................3-19
3-33. Z0 (Self-Test Command) .................................................................3-19
3-34. (Device-Clear Command)................................................................3-20