Filter
Top Products
Removing and installing cable management finger assemblies
The SAN384B comes equipped with two vertical cable management finger
assemblies. It can continue to operate during the replacement of the cable
management assemblies. Due to the horizontal orientation of the blades, the cable
management assemblies are attached to the uprights of the mounting rack.
Time and items required
The replacement procedure for the cable management fingers takes less than five
minutes. A #1 Phillips screwdriver is required.
Removing a cable management finger assembly
To remove the cable management finger assembly:
1. Remove the chassis door.
2. Remove the cables from the cable management finger assembly and rearrange
the cables around the assembly.
3. Unscrew and save the two screws that attach the cable management assembly
to the rack upright (see Figure 32 on page 63). Support the assembly to prevent
it from falling.
4. Remove the cable management assembly.
5. If necessary, repeat steps 1-3 for the other cable management assembly.
384b015
Figure 31. Chassis door
62 SAN384B Installation, Service, and User Guide
|