Filter
Top Products
2. Verify with the customer that the ICL license is installed on each chassis to be
connected. Enter the licenseIdShow command for each chassis. If required,
install the ICL license, following the instructions included with the license.
3. Remove the chassis door (“Removing and installing the chassis door” on page
61).
4. Determine the cable routing and ICL sockets on the core switch blades that you
will be using to connect the two chassis. Refer to Figure 45 on page 87 and
Figure 46 on page 88 for two possible valid options.
5. Remove the EMI plugs from the ICL sockets that you will be connecting. Save
the EMI plugs for possible future use.
6. Install the two ICL cables (“Installing an ICL cable” on page 85).
7. Install the chassis door (“Removing and installing the chassis door” on page
61).
8. Enable the inter-chassis links. See the iclCfg section in the Fabric OS Command
Reference Manual for CLI command options.
9. Verify the operation of the ICL (see Table 17 on page 84).
Chapter 6. Installing new features 117