Filter
Top Products
Chapter 3 Basic Functions
II-54
(iii) As a result of the setting, the following information is displayed in the dialog.
Table 3-16 Execution Result Dialog
Message State
“Setting has been completed” Execution result is in normal
“Setting information is incorrect” Parameter Error
“Same name exists” Same name exists
“Error occurred in the access to the Disk Array
Subsystem”
Access error occurred.
“Cannot execute the demand during the suspension
of the object Disk Array Subsystem monitoring”
Setting is unavailable due to monitoring stop
“Cannot execute the demand during configuration
setting”
Setting is unavailable due to under
configuration setting
“Demanded process has already been executed” Already executed.
“Setting failed (nn)” Other errors (nn is a decimal Detail Code.)
*Other Errors*
When “Setting Failed (nnh)” is displayed for setting process of logical disk name, it is considered that
the errors are detected after completion of I/O for disk array. Check by the browser whether the disk
array setting has been executed, and set again if necessary.
(6) Port Name Setting Conditions and Naming Rules
(a) Setting conditions
Port name should be set with the following conditions. (Settings other than those listed below are processed as
parameter error.)
• 1-byte alphanumeric characters including upper- and lowercase characters. (When configure a name with plural
information, “/”or “_” can be input)
• Maximum number of characters: 32
(b) Naming rules
As well as the disk array name and the logical disk name, it is recommended to set a port name that matches with
the identification information for the system being operated.
In addition, when port name is not set, “16 characters peculiar to disk array + 2 characters of director number + 2
characters of port number” for the port name is set as default value at the time of shipment.
You can set a name to a port only for a host. In the [Disk Array Subsystem Name/Port Name Setting] dialog box,
only the number of the port for a host is displayed.