Filter
Top Products
Chapter 3 Basic Functions
II-46
3
3
3
.
.
.
2
2
2
.
.
.
2
2
2
D
D
D
e
e
e
s
s
s
c
c
c
r
r
r
i
i
i
p
p
p
t
t
t
i
i
i
o
o
o
n
n
n
o
o
o
f
f
f
S
S
S
c
c
c
r
r
r
e
e
e
e
e
e
n
n
n
a
a
a
n
n
n
d
d
d
O
O
O
p
p
p
e
e
e
r
r
r
a
a
a
t
t
t
i
i
i
o
o
o
n
n
n
This section describes the instructions of status monitoring information display image and monitoring control operation
in the iSM client.
(1) Monitoring information display
Information monitored by the iSM server is displayed as “Message Output” and “Status Value Reflection” via
iSM client.
(a) Message Output
When the status transition, name change, or configuration change is detected, messages corresponding to
such events are output in the message display area.
Example of message output at fault detection
Sat Jan 6 02:08:44 2001 0000017917 Info iSMrmond
iSM07102:State of PD(28h) has become fault. (Storage4100/07 ProductID=S4100 Disk Array
SN=3000000000000002 No=00h-01h RankNo=00h-00h) ... (i)
(i) indicates that a fault occurred in the physical disk (with a resource type of 28h, product ID of S4100 Disk
Array, serial number of 3000000000000002, number of 00h-01h, and Rank number of 00h-00h) of the disk
array (whose disk array name is “Storage4100/07”).
Example of message output at name change
Sat Jan 6 02:08:44 2001 0000017917 Info iSMrmond iSM07201:Disk Array, named
Storage4100/07, has renamed to Storage4100/dwh1 (SN=3000000000000003 )
The message indicates that the disk array (whose name is “Storage4100/07” and serial number is
“3000000000000003”) has been renamed “Storage4100/dwh1”.
For details, refer to the “Messages Handbook”.
(b) State Value Reflection
Due to the detection of status transition, name change, or configuration change, respective status of changed
elements is shown in the configuration display area on iSM client.
When events such as fault, caution, and offline occur in each component, status value of the object element
for individual element layer is changed and the corresponding icons are also changed. Status of element
layer or disk array layer change depends on the status change of individual element layer. For example, if
attention event occurs in PD, PD of the upper element layer and disk array layer change to normal status
(maintenance). (Table 3-12)
Furthermore, when two types of event at different fault level simultaneously occur in the individual element
layer, an event with higher fault level is always reflected on the upper layer.
For contents of display, refer to 3.1 “Configuration Display” in this manual.