Filter
Top Products
Chapter 3 Basic Functions
II-12
(iv) Product ID
Displays the product model name (maximum of 16 characters) in the disk array.
(v) Product FW Rev
Displays the Product Revision (4 characters) in the disk array.
(vi) Serial Number
Displays the product number (16 characters) in the disk array.
(vii) SAA
The identification information of disk array. The display contents are the same as (1) “Disk Array Subsystem list
screen”
(viii) World Wide Name
Displays the WWNN (World Wide Node Name) of the disk array.
This item is not displayed if the iSM of the server is Ver1.5 or earlier.
(ix) Total Capacity
Displays the total capacity of physical disk (total capacity of data disk) of the disk array in Gigabyte units (1 G
byte=1,073,741,824 byte) and Terabyte units. (1 T byte = 1,024 G byte).
(x) Control Path
Displays the control path to the disk array in the iSM server by the IP Address (in the case of LAN connection) or
FC pathname (disk information). Displays the path currently controlled (upper layer) and the path for switching
on the fault (lower layer), and displays “
” which indicates a fault next to the control pathname when a fault
occurs in switching paths on the fault.
Example 1) LAN connection:
Control Path (1): 123.123.123.1
Control Path (2): 123.123.123.2
Example 2) FC-AL connection
Control Path (1): disk9 (Port6 Bus0 Target40 Lun4)
Control Path (2): disk10 (Port6 Bus0 Target40 Lun5)
If switching path on the fault does not exist, display “-” in Control Path (2).
(xi) Cross Call
Displays any of the following as setting information for Cross Call function.
ON: Cross Call is valid
OFF (Auto Assignment OFF): Cross Call is invalid and Auto Assignment function is invalid
OFF (Auto Assignment ON): Cross Call is invalid and Auto Assignment function is valid
-: Cross Call function is not supported
(xii) CachePartitioning Function
As information about CachePartitioning function, either of the status below is displayed. This column does not
appear when CachePartitioning is not purchased.
ON CachePartitioning function is applied
OFF CachePartitioning function is not applied
(xiii) User System Code
If the user has made a contract for the maintenance service, the 10-digit user system code is displayed. If not,
“0000000000” is displayed.