Filter
Top Products
Chapter 5 Normal Operation
III-58
(2) Partition List
Lists information about the partitions of the specified pool.
Start Address(h): Start address of the LD or free area
End Address(h): End address of the LD or free area
Capacity(GB): LD capacity in units of GBs.
LDN(h): The logical disk number is displayed in format of LD No. “free” is displayed if the LD has
not been bound.
* Partition List is displayed only for the disk arrays with pool.
* If a specified pool does not exist, the error message as shown below is displayed.
iSM11182:Pool doesn’t exist.
(11) List of snapshot pool
If the -spl option is specified, the system lists information about the snapshot pool of the specified disk array.
#iSMview –spl Storage001
--- Snapshot Pool Information ---
Pool No.(h) Pool Name Threshold
0000 Pool000 ---
0001 Pool001 ---
0002 Pool002 exceeded
(1) Snapshot Pool Information
Lists the snapshot pool bound in the disk array.
Pool No.(h): Pool number
Pool Name: Pool name
Threshold: Threshold state
exceeded: The snapshot used capacity exceeds the threshold.
---: The snapshot used capacity does not exceed the threshold.
* If no snapshot pool exists, the error message as shown below is displayed.
11183 Snapshot Pool doesn’t exist.