Filter
Top Products
TASCAM HS-4000 77
10 – Internal settings
BWF–J Tally
When not operating in BWF–J mode (when the Follow BWF-J
item is OFF), set whether a BWF–J tally is output.
Setting buttons:
OFF (default), ON
NOTE
BWF-J tallys are always output when BWF-J mode is on.
RS–232C page
Make RS-232C serial control transmission settings on this page.
Serial Mode
Set the serial connection mode with the following buttons.
RS–232C support is planned for a future firmware version
upgrade.
Setting buttons:
RS–232C, RS–422 (default)
NOTE
・ The RS-232C and RS-422 connectors cannot both be used at the same
time. Only the connector selected with this setting is operable.
・ This setting is synchronized with the Serial Mode item on the RS-422
page.
Baud Rate (bps)
Set the transmission speed (baud rate) with these buttons.
Setting buttons (bps):
4800, 9600, 19200 and 38400 (default)
Data Length
Set the data length in bits with these buttons.
Setting buttons (bits):
7 or 8 (default)
Parity Bit
Set whether or not there is a parity bit with these buttons.
Setting buttons:
NONE (default), EVEN and ODD.
Stop Bit
Set the stop bit with these buttons. The options are 1 (default
setting) and 2.
Setting (bit):
1 (default) or 2
RS–422 page
Make RS-422 serial control transmission settings on this page.
Serial Mode
Set the serial connection mode with the following buttons.
RS–232C support is planned for a future firmware version
upgrade.
Setting buttons:
RS–232C, RS–422 (default)
NOTE
・ The RS-232C and RS-422 connectors cannot both be used at the same
time. Only the connector selected with this setting is operable.
・ This setting is synchronized with the Serial Mode item on the RS-232C
page.
Video Resolve
When slaving this unit to a VCR, video sync signals might be used
instead of word sync signals for the common standard clock. In
the same way as with word sync signals, you can select whether
the video clock is followed (synchronizing the beginning of time
code frames with video signal frame edges) or it is independent
from the frame clock.
This must be turned ON to accurately control this unit from a
ideo editor. v
ON (default): Time code frame edges synchronized with video
signal frame edges
OFF: Independent from video frame clock