Filter
Top Products
Introduction: Control Reference Guide
19
Introduction
mode to check EE mode video and audio on the
monitor (EE mode is not available during IEEE1394
input). Press the STOP button to return to the original
video and audio.
16.REW/PREV button
Press to rewind. Select the speed in setup menu No.
102 (FF. REW MAX).
In the PB mode, hold down the SHIFT button and press
the REW button to move to the beginning of the current
or previous clip.
During GUI display (thumbnail display and event list
display), hold down the SHIFT button and press the
REW button to move to the first thumbnail or event.
17.STILL/PAUSE button
Press this button to engage the search mode and
display a still picture. In the search mode, you can use
the search dial for JOG and SHTL (shuttle) operations.
18.STOP button
Press this button to stop. When the setting in setup
menu No. 122 (STOP EE SEL) is PB, you can monitor
still pictures and when set to EE, you can monitor input
video.
19.PLAY/REVIEW button
Press to start playback.
Press this button and the REC button simultaneously to
start recording.
When the play list is displayed, hold down the SHIFT
button and press this button to review (playback
starting 3 seconds before the IN point continuing to 1
second beyond the OUT point) an event at the pointer
position. The overwrite edit mode permits preview of
unfinalized events.
20.TCG switch
21.COUNTER button
Press to switch the counter display of the LCD panel.
Each press of this button changes the counter display
as follows: [CTL (relative position from the beginning)]
➝ [TC (read time code)] ➝ [UB (user bit of the read
time code)].
22.RESET button
Press this button when the LCD panel counter is in the
CTL mode to reset the counter display to [0:00:00:00].
Hold down the TC PRESET button and press this
button when the LCD panel counter is in the TC mode
(read time code) or UB mode (user bit of the read time
code) to reset the time code generator.
When using the on-screen keyboard, use this button to
delete all text, IN points in play lists, etc.
23.TC PRESET button
Set the TC (read time code) or UB (user bit of read time
code) value.
To make a setting, first press this button to change the
flashing digits. However, this function is not available
while in thumbnail mode, play list mode, and USB host
mode.
24.TEXT MEMO/MARKER button
INT REGEN: The internal time code generator
synchronizes with the time code
read by the time code reader from
the P2 card. Select whether to make
TC or UB the REGEN in setup menu
No. 505 (TCG REGEN).
INT PRESET: Uses the internal time code
generator of this unit. Settings can
be preset on the operation panel
and the remote control panel.
➝Refer to “Time Code, User Bit and
CTL” (page 130).
EXT: Uses the external time code input
from the TIME CODE IN connector
or video signal VITC, SLTC, SVITC
and IEEE1394 digital input
connectors. Select in setup menu
No. 507 (EXT TC SEL).
TEXT MEMO: Press this button during recording
and playback where you wish to
enter a text memo. In the thumbnail
screen, press this button to add a
text memo at the start of a clip.
MARKER: In the thumbnail screen, while
pressing the SHIFT button, press
this button to turn marker display of
the clip at the pointer position on
and off.
➝For details, refer to “Attaching
Text Memos” (page 44) and
“Attaching Shot Marks” (page
45).