Filter
Top Products
Setup: Item Settings
119
Setup
Definition of terms:
This menu is used for video settings.
* An underlined setting
indicates an initial value.
515 HD EMBD LTC
0000
0001
OFF
ON
Specifies whether or not LTC data will be superimposed on HD SDI output.
0: Not superimposed
1: Superimposed
518 VITC GEN
0000
0001
OFF
ON
Specifies whether or not the internal time code generator value should be recorded in the
VAUX area.
0: The internal time code generator value is not recorded.
Record the time code value when it is superimposed on input video signals.
1: The internal time code generator value is recorded.
NOTE:
When 1394 is selected as the input signal, the time code signal superimposed on the
compressed input signal is recorded regardless of settings in this menu.
519 UB OUT SEL
0000
0001
SBC
F_RATE
Selects user bits in the LTC data output by the TIME CODE OUT and HD SDI connectors
or user bits in the SBC area (DVCPRO HD only) output via the IEEE 1394 terminal during
playback of clips in 720/24PN, 720/30PN and 720/25PN formats as well as optional AVC-
Intra 1080/24PN, 30PN and 25PN clip formats.
0: Outputs the user bits recorded in the SBC area.
1: Outputs the frame rate information recorded in the VAVX area.
SBC (Sub Code Data) area: This area, which is separate from video and audio data area on a P2 card, stores SMPTE/
EBU compliant time code, recording dates and other information.
VAUX (Video Auxiliary Data) area: An area in the video data area on a P2 card that stores additional information on video
data.
VIDEO
Item Setting
Settings and brief function description
FR
No.
SUPER
DISP.
FR
No.
SUPER
DISP.
601 VIDEO INT SG
0000
0001
0002
0003
0004
100%CB
75%CB
SMPTE
ARIB
BLACK
Sets the internal signal type. SMPTE and ARIB signals are available in HD mode only (black
in SD mode).
0: 100% color bar
1: 75% color bar
2: SMPTE color bar
3: ARIB color bar
4: Black
602 SDI IN MODE
0000
0001
DR OFF
DR ON
Specifies the method for processing HD SDI input. (Available only for DVCPRO HD)
0: Records the 8 higher bits after rounding up the two lowest bits.
1: Records the signal with 8 higher bits, obtained by dynamic rounding.
NOTE:
Records 8 high-order bit signals after rounding off the 2 low-order bits during SD SDI
input.
620
DOWNCON
MODE
0000
0001
0002
CROP
LT-BOX
SQUEEZ
Specifies the picture angle during down-conversion.
0: Side cut mode
1: Letter box mode
2: Squeeze mode
621 UPCONV MODE
0000
0001
0002
S-PANL
CROP
STRECH
Specifies the picture angle during up-conversion.
0: Side panel mode
1: Top and bottom cut in vertical direction
2: Stretch mode
Item Setting
Settings and brief function description
FR
No.
SUPER
DISP.
FR
No.
SUPER
DISP.