Filter
Top Products
14
PRV-LX1
En
2 3 4 5 6 7 8 9 10 11 12 13
1415
1617181920212223
1
242526
Front Panel Facilities
Names of Parts
No.
1
2
3
4
5
6
7
8
Name
STANDBY/ON button
Display sections
PLAY/REC indicator
DISC indicator
EJECT button (0)
Drive 2 cosmetic panel
DVD1, DVD2, HDD (Hard disk Drive)
indicators
DRIVE SELECT button
Function
When the unit is in the standby condition, pressing this button causes the
power to come on; the power indicator (to the left of the button) changes
from orange to green. The main display section indicates system startup.
After system startup is completed, the unit enters “idling condition,” and
as the unit’s display changes to show the current time, the STOP button
lights.
When the unit is in the standby condition, if this button is pressed while
holding the STOP button depressed, the Function Menu’s setting values
will be reset to their factory defaults, and the power will then turn ON.
If the button is held depressed for one second or more when the unit is in
the idling condition, the unit will perform system shutdown, followed by
return to the standby mode (the power indicator will change from green
to orange). In the event operation becomes unstable and manual forced
shutdown is required, hold the button depressed for four seconds or
more.
Lights to indicate operating state of DVD1 and DVD2 drives.
Appears green during PLAY mode, and orange during REC mode.
Located to the right side of DVD1 and DVD2, these indicators light
(orange) to indicate that a disc is loaded.
Press to open/close the disc tray. The DISC indicator flashes from the
time the button is pressed until the disc tray closes fully.
This space is provided to allow the addition of a second DVD drive. When
an additional drive is added here, it is considered “DVD2.”
* For further information regarding expansion drives, consult your dealer.
These indicators light to show which drive has been selected with the
DRIVE SELECT button (the indicator for the selected drive lights green).
Use to select the playback source and destination drive for recording.
When only 1 drive is loaded, pressing the button causes the drive
selection to change alternately between HDD (Hard disk Drive) = DVD1;
when two drives are loaded, the selection changes in the order HDD
(Hard disk Drive) = DVD1 = DVD2 = DVD1&2. When a drive is
selected, the corresponding indicator lights (green). When DVD1&2 is
selected, DVD1 is designated as the playback source.