Filter
Top Products
21
PRV-LX1
En
PLAY
PAUSEDISPLAY
REPEAT
AUDIO SCAN
STEP
RPT A-B
ANGLE
SUBTITLE PREV
NEXT
SETUP
ENTER
RETURN
SEARCH
CLEAR
12
3
456
7
8
9
010
>
TITLE/CHP
FRM/TIME
MENU
SETUP
TOP
MENU
FRM/TIME
STOP
DXX2527
2 Press the SETUP button on the remote control
3 Use the mouse to display and access the
playback control bar.
Press both right and
left mouse buttons
simultaneously.
Control bar is displayed.
\
Press the FUNCTION button to access the function menu
Move the mouse cursor
over the FUNCTION
button and click the
left mouse button.
4 Access from the Keyboard by Assigning a
Function key.
Use main unit setting to assign
FUNCTION button to F1 key.
Function Menu
appears when F1
key is pressed.
7 To Exit the Function Menu
Use either of the following methods:
1 Press the Exit button found on any of the sub-
menus (move mouse cursor over the Exit button
and press the left mouse button).
2 Press the FUNCTION button on the front
panel.
3 Press the
SETUP button on the remote control.
4 Click the right button on the mouse
(Note 6)
.
5 If the Function Menu has been assigned to a
function key on the keyboard, press that key.
Note 6:
Use of the right mouse button to exit the Function Menu
is supported only during display of the main Function menu.
7 Control Bar
The control bar is displayed by simultaneously pressing
the right and left mouse buttons. When the
control bar is displayed, simultaneously pressing the right
and left mouse buttons again will cause the control bar
to be hidden. When the mouse cursor is moved over
the control bar, the cursor pointer arrow
changes
to a hand
. When the hand is displayed, it can
be used to perform the same operations available
with the remote control unit; move the hand over the
desired item and select by clicking the left mouse
button.
The position of the control bar can be changed by
placing the mouse cursor on the left edge and
dragging.
(Note 7)
Note 7:
The movable range of the control bar is limited to the area
not overlapping the OSD display. Also, the new location of
the control bar is reset once the Function Menu is exited.
Basic PRV-LX1 Operations
Control bar