Filter
Top Products
57
PRV-LX1
En
Title Editing / Chapter Editing
Title Trimming
When you wish to cut out the first or last part of a
clip, or to extract the middle part of a clip, use the
Function Menu’s EDIT section = [Title] = [Target
Clip] command to select the clip you wish to edit,
then use the EDIT section’s [Title] = [Editing] =
[Trimming Clip] command to select “Go To Video”.
EDIT section = [Title] = [Editing] = [Trimming Clip]
The control bar displayed in conjunction with the
clip’s playback can be used to designate IN/OUT
points for parts to be deleted. During playback, when
the control bar’s IN button is pressed, that part of
the clip preceding that point will be memorized as a
cut point.
Similarly, pressing the OUT button will result the
memorization of that portion of the video image
following that point as a cut point. Attempts to input
reversed IN/OUT points will be ignored.
Pressing the SAVE button will initiate trimming edit,
and when completed, the screen will return to the
Function Menu. Pressing the CANCEL button will
cause the screen to return to the Function Menu
without completing the edit.
Trimming edit screen
Note 1:
With trimming edit, since direct editing is performed
on the clip selected, the original clip cannot be
restored. If the original clip is to be required later,
begin a new project on the hard disk drive, and copy
the clip or entire project to the newly initiated
project (see page 60 “Project Editing”).
Note 2:
The clip size following trimming must be less than
4.7 GB.
Trimming Start
Play Title / Chapter
Play Time
Trimming End Point
OSD during Trimming
Total Title Time